fluent 边界设置 模拟CFD 流固耦合 传热 流动

The purpose of this tutorial is to simulate a realistic industrial pulverized-coal furnace and compare the results with the measured data. Prerequisites This tutorial assumes that you are familiar with the FLUENT interface and have a good understanding of the basic setup and solution procedures. Some steps will not be shown explicitly. This tutorial uses the mixture fraction/PDF model with the k-epsilon turbulence model and P-1 radiation model. If you have not used these models before, it would be helpful to refer to the FLUENT 6.2 Tutorial Guide.

ansys12.0 fluent教材，是安世亚太员工培训教材，十分有用。

动网格一点资料，关于动网格的一些技巧，大大家可以作为参考。

有关动网格的资料，我也是从网上当的，希望能给大伙有所帮助。呵呵呵

fluent模拟动网格的详细资料 十分珍贵的东西

Purpose of this session • Show you how to use the controls for the Dynamic Mesh (DM) model, based on a few examples • Show you how to write simple UDFs that control the dynamic zones, based on a few examples • Show you the new features in FLUENT 6.2 • To have the examples motivate you – what application might you use the model for ?

Fluent动网格基本流程接收与UDF环境搭建、编写方法、并行处理问题。

FLUENT-MDM-tut-01_2d-falling-box

现在，设计点表给出了更新后的值，它们很好的吻合了由响应面得到的预 测值 【对比由响应面得到预测值15 406Pa和由FLUENT预测得到的值测值。【对比由响应面得到预测值15.406Pa和由FLUENT预测得到的值 FLUENT 预测值 WS7-41