粮仓温湿度检测与控制系统的源程序 运用STC15F2K60S2作为单片微控制器，以DHT11为温湿度传感器，以LCD1602作为显示，制作了一套基于单片微控制器的粮仓温湿度检测及控制系统，可对粮仓的温度湿度进行一定的测量、显示与高低温湿的报警。应用温湿度传感器DHT11，它会把温湿度的数据信息进行不同程度的收集。它是应用单总线通信的数字式温湿度传感器，该系统将通过IO口读取收集到的信息用来一定的操作处理后把温湿度值实时发送到LCD1602上。此外，能够用按键来设定温湿度的额定范围，当温湿度不在所规定的额定范围内就发出警报。

单片机课程设计

做项目时收集的温湿度传感器资料，使用时可以参考设计。

eclipse环境，stm32,ds18b20,dht11,oled(iic)温湿度显示屏，已在stm32f103c8t6上测试通过！！

基于单片机的粮仓温湿度监控系统的设计

基于单片机的粮仓温湿度控制系统设计毕业设计

基于ZigBee和LabView的多点无线温湿度采集系统设计

本文件为模拟IIC驱动TH06的demo程序，The TH06 I2C Humidity and Temperature Sensor is a monolithic CMOS IC integrating humidity and temperature sensor elements, an analog-to-digital converter, signal processing, calibration data, and an I2C Interface. The patented use of industry-standard, low-K polymeric dielectrics for sensing humidity enables the construction of lowpower, monolithic CMOS Sensor ICs with low drift and hysteresis, and excellent long term stability. The humidity and temperature sensors are factory-calibrated and the calibration data is stored in the on-chip nonvolatile memory. This ensures that the sensors are fully interchangeable, with no recalibration or software changes required The TH06 is reflow solderable. It can be used as a hardware- and software-compatible drop-in upgrade for existing RH/ temperature sensors , featuring precision sensing over a wider range and lower power consumption. The optional factory-installed cover offers a low profile, convenient means of protecting the sensor during assembly (e.g., reflow soldering) and throughout the life of the product, excluding liquids (hydrophobic/oleophobic) and particulates. The TH06 offers an accurate, low-power, factory-calibrated digital solution ideal for measuring humidity, dew-point, and temperature, in applications ranging from HVAC/R and asset tracking to industrial and consumer platforms.

硬件线路按照文章连接，打开就能用 STM32F103RCT6、温湿度传感器：DHT11、雨滴传感器 数据动态显示在液晶屏上

此程序设计是基于51单片机开发的，通过DHT11传感器检测空气的温度和湿度，并通过1602液晶显示出来，同时通过串口通信，将其显示在PC机上