Mastering STM32.pdf

This is a book about the STM32 family of 32-bit Flash microcontrollers from ST Microelectronics based on the ARM Cortex-M architecture. The book will guide you in a clear and practical way to this hardware platform and the official ST CubeHAL, showing its functionalities with a lot of examples and tutorials. The book assumes that you are totally new to this family of MCUs, and it will start showing how to setup a complete and totally free software tool-chain to build your STM32 based applications. The installation instructions will allow to setup a complete tool-chain on Windows, Linux and Mac OSX. The book is addressed both to professionals and to fans of this platform, like hobbyists and students. The book examples are based on the sixteen Nucleo-64 boards from ST. This release is composed by twenty-two chapters, divided in about 780 pages. They cover: Introduction to Cortex-M and STM32 microcontrollers How to setup a complete and working tool-chain to develop STM32 applications on Windows, Linux and Mac OSX How to use STM32CubeMX to generate application skeleton, and how to import it inside the tool-chain Introduction to OpenOCD and to the debugging of STM32 applications ARM semihosting GPIO management NVIC controller UART peripheral DMA controller STM32 clock tree and its configuration Basic, general purpose and advanced STM32 timers ADC peripheral DAC controller I2C bus and protocol SPI bus Power management The memory layout of an STM32 application and linker scripts Flash memory management and the role of the ART Accelerator The booting process in STM32 microcontrollers and how to write a custom bootloader FreeRTOS and the tickless low-power mode Advanced debugging techniques and how to use SEGGER tools to debug STM32 MCUs How to design a custom board using an STM32 MCU