Uart串口读写实验Cyclone10 FPGA实验Verilog源码Quartus17.1工程文件+文档资料.zip

Uart串口读写实验Cyclone10 FPGA实验Verilog源码Quartus17.1工程文件+文档资料, FPGA为CYCLONE10LP系列中的10CL025YU256C8. 完整的Quartus工程文件，可以做为你的学习设计参考。 module uart_test( input clk, input rst_n, input uart_rx, output uart_tx ); parameter CLK_FRE = 50;//Mhz localparam IDLE = 0; localparam SEND = 1; //send HELLO ALINX\r\n localparam WAIT = 2; //wait 1 second and send uart received data reg[7:0] tx_data; reg[7:0] tx_str; reg tx_data_valid; wire tx_data_ready; reg[7:0] tx_cnt; wire[7:0] rx_data; wire rx_data_valid; wire rx_data_ready; reg[31:0] wait_cnt; reg[3:0] state; assign rx_data_ready = 1'b1;//always can receive data, //if HELLO ALINX\r\n is being sent, the received data is discarded always@(posedge clk or negedge rst_n) begin if(rst_n == 1'b0) begin wait_cnt <= 32'd0; tx_data <= 8'd0; state <= IDLE; tx_cnt <= 8'd0; tx_data_valid <= 1'b0; end else case(state) IDLE: state <= SEND; SEND: begin wait_cnt <= 32'd0; tx_data <= tx_str; if(tx_data_valid == 1'b1 && tx_data_ready == 1'b1 && tx_cnt < 8'd12)//Send 12 bytes data begin tx_cnt <= tx_cnt + 8'd1; //Send data counter end else if(tx_data_valid && tx_data_ready)//last byte sent is complete begin tx_cnt <= 8'd0; tx_data_valid <= 1'b0; state <= WAIT; end else if(~tx_data_valid) begin tx_data_valid <= 1'b1; end end WAIT: begin wait_cnt <= wait_cnt + 32'd1; if(rx_data_valid == 1'b1) begin tx_data_valid <= 1'b1; tx_data <= rx_data; // send uart received data end else if(tx_data_valid && tx_da