CC2510串口无线透传程序，直接就可以用，直接就是产品。在CC2510中可以直接使用。使用半双工模式。里面有各种功能有中文注释。

cc2510基础例程，学习、开发作为参考

CC2510 无线单片机开发源程序，例程

简要介绍无线传感器网络节点结构的基础上，对Chipcon公司开发的内嵌51内核的单片可编程UHF收发器芯片CC2510的功能特点进行了研究，并结合其工作原理与应用电路,对无线传感器网络节点的各个功能模块及设计要点进行了详细阐述。最后基于CC2510的原理设计了一个新的无线传感网络。由该节点组成的无线传感器网络功耗低、节点体积小, 可以广泛地应用于各类无线数据通讯、军事侦察、环境监测、安防系统等领域

void radioConfigure_rx() { PA_TABLE0 = 0xFE;//1=0xff,-2=0xbf,-6=0x7f,-10=0xcb,-16=0x87,-20=0xc1,-30=0x44 /* FREQ2 = 0x5F;// 2480 MHz FREQ1 = 0x62; FREQ0 = 0x76;*/ FREQ2 = 0x5E;// 2460 MHz FREQ1 = 0x9D; FREQ0 = 0x89; /* FREQ2 = 0x5D;// 2440 MHz FREQ1 = 0xD8; FREQ0 = 0x9D; FREQ2 = 0x5D;// 2420 MHz FREQ1 = 0x13; FREQ0 = 0xB1; */ FSCTRL1 = 0x0A; // Frequency synthesizer control. FSCTRL0 = 0x00; // Frequency synthesizer control. MDMCFG4 = 0x2D; // Modem configuration. MDMCFG3 = 0x3B; // Modem configuration. MDMCFG2 = 0x73; // Modem configuration. MDMCFG1 = 0x22; // Modem configuration. MDMCFG0 = 0xF8; // Modem configuration. DEVIATN = 0x00; // Modem deviation setting (when FSK modulation is enabled). FREND1 = 0xB6; // Front end RX configuration. FREND0 = 0x10; // Front end RX configuration. MCSM0 = 0x14; // Main Radio Control State Machine configuration. FOCCFG = 0x1D; // Frequency Offset Compensation Configuration. BSCFG = 0x1C; // Bit synchronization Configuration. AGCCTRL2 = 0xC7; // AGC control. AGCCTRL1 = 0x00; // AGC control. AGCCTRL0 = 0xB2; // AGC control. FSCAL3 = 0xEA; // Frequency synthesizer calibration. FSCAL2 = 0x0A; // Frequency synthesizer calibration. FSCAL0 = 0x11; // Frequency synthesizer calibration. TEST2 = 0x88; // Various test settings. TEST1 = 0x31; // Various test settings. TEST0 = 0x0B; // Various test settings. // Common radio settings for CCxx10, any frequency and data rate CHANNR = 0x00; // Channel num