为实现控制简单可靠,系统动态响应快,Boost有源功率因数校正(APFC)采用单周期控制的非线性控制策略.本文对单周期控制的Boost APFC进行理论分析,并基于Simulink完成建模和仿真.实现设计电路输入功率因数高、输出电压纹波小、电流畸变率小.
2022-06-13 10:53:48 336KB 自然科学 论文
1
针对传统的光伏并网发电系统存在输出电压低且波动范围大,能耗大,可靠性差等问题,提出了一种基于单周期控制的Z源光伏并网逆变器的设计方案,分析了Z源逆变器的电路结构及特点,详细介绍了Z源逆变器单周期控制策略的实现,并采用Matlab/Simulink建立了仿真模型。实验结果表明,Z源逆变器具有良好的升压作用,降低了对光伏电池电压等级的要求;采用单周期控制技术能够很好地跟踪电网电压,从而实现了单位功率因数。
2022-05-24 20:57:57 172KB 行业研究
1
分析了有源滤波器的工作原理,推导了三相三线制有源滤波器单周期控制的数学模型;将数字单周期控制与ip-iq谐波电流检测法相结合,实现了对有源滤波器的控制。与传统单周期控制方法相比较,该方法保留了实时性好、鲁棒性好等优点,又取消了积分器,降低了单周期控制电路的复杂性。使用Matlab/Simulink软件对该方法进行了仿真,并在以DSP为核心的试验平台上进行了验证,仿真和试验结果都证明了该方法的可行性与有效性。
1
随着电力电子技术的不断发展,带非线性负载的电力电子装置在电网中得到广泛应用并产生大量电流谐波,电力系统的波形畸变及由此产生的谐波不仅大大降低了系统的功率因数,而且也给系统带来了危害。   寻求更加简单的控制策略,降低PFC成本,减少总谐波含量(THD)和EMI,目前对三相功率因数校正方面的研究主要集中在控制策略和拓扑结构方面。控制策略的研究主要集中在电流型控制、多环控制、单周期控制、矢量控制等方面。采用单周期控制技术控制三相整流器以减小电流畸变,使输入电流在每个开关周期都能很好跟踪参考电流,使直流输出端存在大量电流谐波时,也能实现较小的输入电流畸变,从而实现高功率因数整流。   1 整流器
1
存数(sw)指令的数据通路 M[ R[rs] + SignExt[imm16] ] ← R[rt] Example: sw rt, rs, imm16 32 ALUctr Clk busW RegWr 32 32 busA 32 busB 5 5 5 Rw Ra Rb 32 32-bit Registers Rs Rt Rt Rd RegDst Ext Mux Mux 32 16 imm16 ALUSrc ExtOp Mux MemtoReg Clk Data In WrEn 32 Adr Data Memory 32 MemWr ALU RegDst=x, RegWr=0, ALUctr=add, ExtOp=1, ALUSrc=1, MemWr=1, MemtoReg=x 0 1 0 1 加兰色部分。才能向存储器存数 0 1 op rs rt imm16 0 16 21 26 31 6 bits 16 bits 5 bits 5 bits And here is the datapath for the store instruction. The Register File, the ALU, and the Extender are the same as the datapath for the load instruction because the memory address has to be calculated the exact same way: (a) Put the register selected by Rs onto bus A and sign extend the 16 bit immediate field. (b) Then make the ALU (ALUctr) adds these two (busA and output of Extender) together. The new thing we added here is busB extension (DataIn). More specifically, in order to send the register selected by the Rt field (Rb of the register file) to data memory, we need to connect bus B to the data memory’s Data In bus. Finally, the store instruction is the first instruction we encountered that does not do any register write at the end. Therefore the control unit must make sure RegWr is zero for this instruction. +2 = 64 min. (Y:44)
2022-04-10 21:09:08 4.02MB ics
1
单周期控制BoostDC/DC变换器分析与设计.zip
2022-01-11 16:02:30 192KB 资料
单周期控制BoostDC_DC变换器分析与设计
2021-12-30 12:49:26 225KB 单周期控制 Boost DC_DC
1
boost_APFC.mdl
2021-10-27 21:02:25 67KB 单周期控制
1
BUCK变换器的单周期控制-V_2_OCC控制Buck变换器.rar BUCK变换器的单周期控制 中文文献
2021-10-10 21:41:39 1.13MB matlab
1
MATLAB单周期控制PFC_Boost变换电路建模仿真pdf,
2021-04-21 17:59:35 718KB 开关电源
1