荣欣网卡路由器5固件，1.9.2版本固件升级，官网固件最新版本RX5-6都可以用6666666666666

pycharm的2019版本汉化包，基于共享分析给大家，具体使用方法可以直接百度，放在lib文件夹下即可

六足仿生蚂蚁机器人silodworks

自动配网，傻瓜式本地升级4338固件 ，程序安装，一键开启氛围灯，此工具来源于网络不可做任何商业用途。

iPod+Authentication+Coprocessor+Spec+2.0C+R1Contents Chapter 1 Introduction 7 Overview 7 Authentication protocol 7 Terminology Used in This Document 8 General Specification Terms 9 s Related documents 9 Chapter 2 Signal Descriptions and Reference Circuit 11 CP Signals and Pinouts 11 Address selection 12 Reference circuit 12 Chapter 3 Hardware Configuration and Interface 13 System Voltage/ 13 Startup of the 12C Interface/13 Starting Up the cp by turning power on /13 Starting Up the Cp by Warm Reset 14 Communication Process15/ Low-Power Sleep Mode-16 Chapter 4 Coprocessor Registers 17 Register Addresses 17 Register Descriptions 19 Device version 19 Firmware version 19 Authentication Protocol Major and Minor Versions 20 Device iD 20 Error Code 20 Authentication Control and status 21 Signature Data Length 22 Signature Data 22 hallenge Data Length 23 Challenge data 23 Accessory Certificate Data Length 23 Accessory Certificate Data 23 Self- Test Control and status 23 System Event Counter 24 Apple Device Certificate Data Lengt 3 2011-06-22 I @2011 Apple Inc. All Rights Reserved. CONTENTS Apple device certificate data 25 Chapter 5 Authentication Data flows 27 Apple Device Authentication of Accessory 27 Accessory Authentication of the Apple Device 28 Chapter 6 12C Communication Protocol 31 Slave selection and reset 31 s Coprocessor Busy. 31 Writing to the Coprocessor 31 Reading from the Coprocessor 32 Chapter 7 CP Device Characteristics 33 Physical Configuration 33 Maximum Environmental Conditions 33 Recommended Operating Conditions 34 12C Interface Characteristics 34 DC Electrical Characteristics 34 Timing Characteristics 35 ppendix a Coprocessor 2.0B to 2.0C Migration Guide 37(Ay Only 12C Communication Protocol 37 Increased SCL Speed 37 Shorter Reset Cycle 37 Warm Reset Supported 37 Automatic Sleep State Entry and Exit 38 NACK Responses Replace Clock Stretching 38 Shorter Accessory Certificate Data 38 System Event Counter Must Be Zero Betore Power-Down 38 Document Revisio

海思所需资源

CompactPCI Express PICMG EXP.0 R1.0 Specification, 目前最新版的CPCI EXPRESS 总线规范

LT8618SX Low Power HDMI Transmitter Features  RGB Input  Support 24-bit RGB，YUV and BT656/BT601/BT1120 Input  Support both SDR and DDR Data Sampling  Programmable Rising/Falling Edge Clock Input  Support up to 148.5MHz DDR or 297MHz SDR Clock Input  Support both 1.8V and 3.3V Input Voltage Level  HDMI Transmitter  Compliant with HDMI1.4 and HDCP1.4  Resolution Up to 4K 30Hz  Programmable output swing and pre-emphasis  Fully hardware-controlled or optional software- controlled HDCP operations  Pre-programmed HDCP key sets or external EEPROM stored key sets  Integrated CEC controller  Integrated EDID shadow RAM and embedded EDID  5V tolerance DDC/HPD I/Os  Miscellaneous  1.8V and 3.3V Power Supply  Support 100KHz and 400KHz I2C slave  Support up to 8-channel Audio Input  Temperature Range: -40°C ~ +85°C  Pin compatible with SiI9030，ANX9030 and CAT6612  Packaged in LQFP80 12mm x 12mm and QFN64 9mm x 9mm Description The LT8618SX is Lontium’s low power version HDMI transmitter based on ClearEdgeTM technology. It supports the 24-bit color depth HDMI 1.4 (High Definition Multimedia Interface) specification. They are fully backwoard compatible with Lontium’s first generation HDMI transmitter LT8618EX, and also pin compatible with Silicon Image SiI9030 and Analogix ANX9030 transmitters. LT8618SX is a high performance, low power part that are specifically designed for HD-Digital cameras, HD-Digital Video Cameras, HD-PMP/MP4 Players, Cell phones, etc. The normal operation power is less than 100mA playing 24bit 1080P content, and the standby power is less than 2mA. Applications  DVD, BD  Car Video Recorder  PTV Box  HD Sources

iphone carplay认证，iAP2 Sample Source R1代码。 iAP2 sample的代码，可以参考下

Ansys.Electronics.2021.R1.Win64-SSQ，2021年最新版本，具体改进了什么也没注意，可以下载，迅雷很慢，FDA速度一般，挂了好几小时才下载完成。